Home Cigar 101

Catfish: How to season or reaseason a humidor using Kitty Litter or Beads

1234689

Comments

  • CigaryCigary Everyone, Registered Users Posts: 623
    Roberto99:
    I'm interested in what others will say about this. What I did in a similar situation is kept my humicare humidifier and added about 1/2-3/4 lb of kl in a nylon sock. That way when I need to add water to the system I just add it to the humicare device. I think the litter pearls would need a little spritz first but that might depend on the current ambient humidity in your area. If the humidity is high, then no.
    From experience I've used the "socks" and finally went to a shallow container only because you're able to expose more KL with this type than a sock. A shallow container like...1 1/2 high by any width and length as you want....KL works best when it is exposed. When it's in one of those socks you're losing at least 70% of what is inside unless you roll it around on the floor and spritz/spray until the KL gets drenched...that isn't what you want because the KL tends to give off a funky smell when it has too much DW on it. Spraying is your best bet and being able to expose as much surface area is your next best bet...JMHO from 2 years experience.
  • RhamlinRhamlin Everyone, Registered Users Posts: 4,530
    So after a week I got back from my trip all my humi's were around 61-62%. I added a little water to each of my humidifiers so far each humi reads 63%. Is this pretty standard or can I get it up to 65% by adding more water?
  • ddubridgeddubridge Everyone, Registered Users Posts: 3,949
    You can get there. Just take it slow and don't over do it. Eventually you will get to a point they will say at the rh you want them at. Then you'll be on the one month cycle.
  • RhamlinRhamlin Everyone, Registered Users Posts: 4,530
    Thanks Drew . I got my main right at 68% holding steady for about 15 hours now. Haven't checked the small ones yet today. Will do that here in a bit. Got to get me a couple more hygrometers. I make do with one so it takes time to do all 3.
  • perkinkeperkinke Everyone, Registered Users Posts: 1,562
  • macs-smokesmacs-smokes Everyone, Registered Users Posts: 585
    Bump to help with some questions.
  • catfishbluezzcatfishbluezz Everyone, Registered Users Posts: 6,993
    Funny, I am seasoning a humi now for a friend. i just closed it up for over a week without opening. I'm interested to see where it's at.
  • RhamlinRhamlin Everyone, Registered Users Posts: 4,530
    Loving the KL. Thanks Drew I owe you brother.
  • ddubridgeddubridge Everyone, Registered Users Posts: 3,949
    Rhamlin:
    Loving the KL. Thanks Drew I owe you brother.
    You dont owe me $hit!
  • catfishbluezzcatfishbluezz Everyone, Registered Users Posts: 6,993
    Bump for SmokeWI
  • Proper StrangerProper Stranger Everyone, Registered Users Posts: 5
    Is there a good way to estimate how much KL you need for a given space? I understand more is better, but I'd like to save as much room as possible, for obvious reasons. I have a new humidor 18x11x9 coming in the next couple days.

    What do you think? A 1.5 pounds or so?
  • Bob LukenBob Luken Everyone, Registered Users Posts: 3,664
    Proper Stranger:
    Is there a good way to estimate how much KL you need for a given space? I understand more is better, but I'd like to save as much room as possible, for obvious reasons. I have a new humidor 18x11x9 coming in the next couple days.

    What do you think? A 1.5 pounds or so?
    Take a look at heartfelt industries website. There is a calculator there that lets you enter length, height and width of your humidor in the form and it calculates how much of their silica product to use. Then I would double it for use with silica kitty litter. I put the measurements you gave into the calculator on their site and it said 4 ounces. Double it and you get 1/2 pound.

    http://heartfeltindustries.com/calculator.asp

    Also, I assume you've studied up on the "right" kind of kitty litter. 100% silica. Odor free. I started a list of "good" cat litter and "bad" cat litters a while back. Take a look.

    http://www.cigar.com/cs/forums/ShowThread.aspx?PostID=660893#660564
  • ddubridgeddubridge Everyone, Registered Users Posts: 3,949
    Bob Luken:
    Proper Stranger:
    Is there a good way to estimate how much KL you need for a given space? I understand more is better, but I'd like to save as much room as possible, for obvious reasons. I have a new humidor 18x11x9 coming in the next couple days.

    What do you think? A 1.5 pounds or so?
    Take a look at heartfelt industries website. There is a calculator there that lets you enter length, height and width of your humidor in the form and it calculates how much of their silica product to use. Then I would double it for use with silica kitty litter. I put the measurements you gave into the calculator on their site and it said 4 ounces. Double it and you get 1/2 pound.

    http://heartfeltindustries.com/calculator.asp

    Also, I assume you've studied up on the "right" kind of kitty litter. 100% silica. Odor free. I started a list of "good" cat litter and "bad" cat litters a while back. Take a look.

    http://www.cigar.com/cs/forums/ShowThread.aspx?PostID=660893#660564
    You could also save room by drilling holes in a tubo and filling it with KL. It's the size of a cigar and fits well in a humi. Just a thought.
  • onestrangeoneonestrangeone Everyone, Registered Users Posts: 1,423
    ddubridge:
    Bob Luken:
    Proper Stranger:
    Is there a good way to estimate how much KL you need for a given space? I understand more is better, but I'd like to save as much room as possible, for obvious reasons. I have a new humidor 18x11x9 coming in the next couple days.

    What do you think? A 1.5 pounds or so?
    Take a look at heartfelt industries website. There is a calculator there that lets you enter length, height and width of your humidor in the form and it calculates how much of their silica product to use. Then I would double it for use with silica kitty litter. I put the measurements you gave into the calculator on their site and it said 4 ounces. Double it and you get 1/2 pound.

    http://heartfeltindustries.com/calculator.asp

    Also, I assume you've studied up on the "right" kind of kitty litter. 100% silica. Odor free. I started a list of "good" cat litter and "bad" cat litters a while back. Take a look.

    http://www.cigar.com/cs/forums/ShowThread.aspx?PostID=660893#660564
    You could also save room by drilling holes in a tubo and filling it with KL. It's the size of a cigar and fits well in a humi. Just a thought.
    I've done this, works well for a 20ct I used a 7/64 bit witch may have been a tad to large some of small particles come thu as sand I wrapped it with nylons, I also had to run a peice of dowel inside the tube to keep it from fraying.
  • ddubridgeddubridge Everyone, Registered Users Posts: 3,949
    onestrangeone:
    ddubridge:
    Bob Luken:
    Proper Stranger:
    Is there a good way to estimate how much KL you need for a given space? I understand more is better, but I'd like to save as much room as possible, for obvious reasons. I have a new humidor 18x11x9 coming in the next couple days.

    What do you think? A 1.5 pounds or so?
    Take a look at heartfelt industries website. There is a calculator there that lets you enter length, height and width of your humidor in the form and it calculates how much of their silica product to use. Then I would double it for use with silica kitty litter. I put the measurements you gave into the calculator on their site and it said 4 ounces. Double it and you get 1/2 pound.

    http://heartfeltindustries.com/calculator.asp

    Also, I assume you've studied up on the "right" kind of kitty litter. 100% silica. Odor free. I started a list of "good" cat litter and "bad" cat litters a while back. Take a look.

    http://www.cigar.com/cs/forums/ShowThread.aspx?PostID=660893#660564
    You could also save room by drilling holes in a tubo and filling it with KL. It's the size of a cigar and fits well in a humi. Just a thought.
    I've done this, works well for a 20ct I used a 7/64 bit witch may have been a tad to large some of small particles come thu as sand I wrapped it with nylons, I also had to run a peice of dowel inside the tube to keep it from fraying.
    Great advice! Never thought of the dowel.
  • BigT06BigT06 Everyone, Registered Users Posts: 3,899
    Quick update on my experience with KL...

    Catfish sent me some KL to add to my set up a while back. I used the 5 lbs of beads I already had to help train the litter (by placing the KL in a small cooler with the beads and slowly wetting them for a few days until they could hold 66% by themselves with the beads removed). The KL has done well in my set up, and I feel that when used properly it can be a great media source for RH. That being said, I will always have beads in my coolers as well for simple peace of mind, but I will never buy beads again. I will simply add more KL and spread out the beads more as my inventory expands.
  • CigaryCigary Everyone, Registered Users Posts: 623
    That's what happened with me...I progressed from beads to KL..one humidor at a time and now all 30 humidors are KL only. It's like setting your watch...easy and it works all the time. Welcome to the KL train.
  • catfishbluezzcatfishbluezz Everyone, Registered Users Posts: 6,993
  • ldmanldman Everyone, Registered Users Posts: 19
    catfish,
    Thank you for this thread. As you know in a thread I started, that I'm new to all of this and am already having Humidor issues. I took my smokes out of the box today. Got rid of the foam humi that came with it. ordered some beads today. I'll let you know how things go when I re-season my box "Per your instructions.
    Thanks!
  • catfishbluezzcatfishbluezz Everyone, Registered Users Posts: 6,993
    Feel free to post any quetions here. i am not here as much as I used to be, but many of the guys have used this method and understand it well. Good luck bro, we'll get ya squared away real quick.
  • New BootsNew Boots Everyone, Registered Users Posts: 2,634
    I may just start it over. its empty, and im not hurt for space. yours sounds tried and true.
  • ehehatehehat Everyone, Registered Users Posts: 1,534
    New Boots:
    I may just start it over. its empty, and im not hurt for space. yours sounds tried and true.
    I used this method on 2 humis and told friends how've used it on at least 3 more. It just works.
  • New BootsNew Boots Everyone, Registered Users Posts: 2,634
    ehehat:
    New Boots:
    I may just start it over. its empty, and im not hurt for space. yours sounds tried and true.
    I used this method on 2 humis and told friends how've used it on at least 3 more. It just works.
    I have a feeling this will be my method of choice from now on. As long as my patience holds out
  • danielruasdanielruas Everyone, Registered Users Posts: 778
    Just started this process three days ago on my new 600ct. I have kitty litter I'll be adding later tonight, I will update on how things go. But thank you very much for this thread!!
  • danielruasdanielruas Everyone, Registered Users Posts: 778
    I am at day 9 I believe rh is stable at 73 and I believe I will take the leap either later or tomorrow and fill it up!
  • onestrangeoneonestrangeone Everyone, Registered Users Posts: 1,423
    Cool Man, sounds like your on a roll!
  • ehehatehehat Everyone, Registered Users Posts: 1,534
    Way to go. the time it takes can be tough- I'm not a patient man, but the results are worth every minute. When I tried the wipe method my RH would go all over the place and i was constantly spraying my KL. Once I started over with this I've never had a problem and only have to spray once every 4-6 weeks.
  • ehehatehehat Everyone, Registered Users Posts: 1,534
    Bump for curtiscr79
  • danielruasdanielruas Everyone, Registered Users Posts: 778
    Ok so it's been a few weeks since I did this seasoning method on my 600ct humi and I've got it all loaded up and it's been holding rock solid at 68% ever since, whenever I open it up it drops down then very quickly jumps back up. Thank you very much catfish I'm super happy with the results!
  • PAtoNHPAtoNH Everyone, Registered Users Posts: 430
    Catfish, I'm adding a Medici/Havana Foot Locker to the mix… it should arrive this week. I want to get the seasoning started so that it might be ready when we return from visiting family over the holidays. I'm planning on using 3 sponges; 1 in the lower compartment and the other 2 on each of the shelves. I hope to be able to get through the initial "sponge days" before we leave, pull the sponges and drop in the beads and hygrometer as we head out the door and come home 5 days later, check for consistent rh over the next two days and have a humi ready for loading. Is this a realistic set of expectations? Any suggestions?
Sign In or Register to comment.