Gotta beef w/ my Hygro

Options
Jetmech_63
Jetmech_63 Everyone, Registered Users Posts: 3,384
I have a problem with my new Xikar digital Hygro. I get it home, put it in a baggie with a cap full of salt wet with water with no standing water on top(standard salt calibration), leave it in there for 24 hrs and reset it to 75%. Just for schitzengigles i put it in my already up and running humi alongside my other Xikar digital hygro and my new one reads 8% higher. Then i get the bright idea to put both in humi that is being seasoned until my known good one reads 75...then i hit the cal button my new one...fool proof right? Not so much, put em both back in my normal humi and the new one now reads 4% higher. Any wisdom, anyone run into this before....and for the record i really dont like the new xikar hygros(the ones with slits on top AND the sides....waaay too damn touchy.

Comments

  • mrpillow
    mrpillow Everyone, Registered Users Posts: 464
    Salt test it and let it sit for longer.
  • Dustin1981
    Dustin1981 Everyone, Registered Users Posts: 410
    Or if your really stuck you can get the Bovida One-Step cal kit.
  • urbino
    urbino Everyone, Registered Users Posts: 4,517
    Dustin1981:
    Or if your really stuck you can get the Bovida One-Step cal kit.
    Yeah, I think that's where I'd go next. Calibrate both of them.
  • The Cank
    The Cank Everyone, Registered Users Posts: 799
    Dustin1981:
    Or if your really stuck you can get the Bovida One-Step cal kit.


    I only use the bovida to calibrate. i dont trust the salt test
  • xmacro
    xmacro Everyone, Registered Users Posts: 3,402
    When I salt test, I always like to stick an extra cap of dry salt in the bag as a control measure, then let it sit for about 36 hrs. You should also know that even digital hygro's require re-calibration from time to time (maybe once every 6mo to a year)
  • cabinetmaker
    cabinetmaker Everyone, Registered Users Posts: 2,561
    Replace both batteries, too. They have trouble reading correctly when battery levels get low. Sometimes when they ship with the original batteries installed, you don't know how long they have sat on a shelf before they were shipped to you. So, even though the batteries might be "new" and unused, they are still weak. I had that exact same problem, replaced both batteries with new ones and they are both spot on.
  • bernard_bus
    bernard_bus Everyone, Registered Users Posts: 18
    Jetmech_63:
    I have a problem with my new Xikar digital Hygro. I get it home, put it in a baggie with a cap full of salt wet with water with no standing water on top(standard salt calibration), leave it in there for 24 hrs and reset it to 75%. Just for schitzengigles i put it in my already up and running humi alongside my other Xikar digital hygro and my new one reads 8% higher. Then i get the bright idea to put both in humi that is being seasoned until my known good one reads 75...then i hit the cal button my new one...fool proof right? Not so much, put em both back in my normal humi and the new one now reads 4% higher. Any wisdom, anyone run into this before....and for the record i really dont like the new xikar hygros(the ones with slits on top AND the sides....waaay too damn touchy.
    Salt test in themselves seem to vary. Seriously, too little and too much water will affect the readings. Zip lock bags are not air tight so normal environmental issues will come into play. I personally stopped using zip lock bags and went to them air tight Tupperware boxes. The ones with little wing looking things and a rubber seal. At least there I *think* you have a better chance to control environmental issues which will/may cause issues with the test results, thus a strange flux in readings.

    Maybe give that a try?
  • bernard_bus
    bernard_bus Everyone, Registered Users Posts: 18
    xmacro:
    When I salt test, I always like to stick an extra cap of dry salt in the bag as a control measure, then let it sit for about 36 hrs. You should also know that even digital hygro's require re-calibration from time to time (maybe once every 6mo to a year)
    that's a good trick there.
  • Russ55
    Russ55 Everyone, Registered Users Posts: 2,762
    The Cank:
    Dustin1981:
    Or if your really stuck you can get the Bovida One-Step cal kit.


    I only use the bovida to calibrate. i dont trust the salt test
    Yeah, me too. I could never get the salt test to work reliably.